Stenter setting machine, can it determine the width of knitted fabrics? Can it adjust the shrinkage of the fabric?
The working principle of the high temperature stenter setting machine is: The unshaped cloth is fed into the shaping machine through the edge stripper. At the same time, the two ends
What is the working principle of the high temperature stenter setting machine? And, are there any other questions about this type of stereotypes machine that we don't know and are familiar with?
When the temperature of the hot air in the room of the fabric setting machine reaches the process requirements, start the main drive, exhaust fan, cooling fan and static electricity remover in sequenc
1. The fabric is pleated and shaped by high-temperature steam to permanently maintain the elasticity of the sundial.
1. Double-layer drying, single-side operation, saving manpower and small footprint. 2. The double-layer Teflon mesh belt supports the floating fabric to dry in a detour, the path is long, the
Loose pre-shrinking dryer is a tension-free relaxation dryer. The hot air blows strongly through the slits of the nozzles that intersect up and down, so that the fabric is rubbed by the wind during th
Preparations before the operation of the stenter setting machine We need to clean the surface of the stenter setting machine equipment, the work surface, etc., especially
It should be noted that the diameter of the ground wire must not reach 3 square millimeters. In addition, during the operation of the stenter setting machine equipment, no repair or inspection work is
Under normal circumstances, every time the stenter setting machine equipment runs for a period of time, it needs to be lubricated and maintained. At the same time, due to the different lengths of runn
It should be noted that in order to ensure the good operation of the stenter setting machine, the staff need to regularly lubricate and maintain the width adjustment device, and also carefully check w
Regarding the operation of the stenter setting machine equipment, there are many problems that need attention. As users, we should not only inspect and maintain it according to the specifications, but
