When the temperature of the hot air in the room of the fabric setting machine reaches the process requirements, start the main drive, exhaust fan, cooling fan and static electricity remover in sequence, lift the cloth feeding roller, pull the gray cloth through the fabric support by the guide rope, and the cloth passes through the roller and each A cloth guide roller is transported to the cloth receiving platform to the cloth frame. Therefore, what needs to be done here is to adjust the feeding and overfeeding wheel according to the fabric setting effect, so that the overfeeding amount and speed meet the requirements. During the running of the gray cloth, the cloth feeding operator should check the speed, temperature, excessive cloth feeding and weft yarn skew at any time, and take corresponding measures to solve the problems found. It is also important that the operator of the fabric setting machine should pay attention to the flatness of the fabric, measure the width of the fabric, check the quality of the fabric, and immediately notify the relevant personnel to deal with the problem or take corresponding measures. After finalizing, the gray cloth should be printed according to the weight of the subpoena, and bagged and stored in the designated place in order, and the production date should be marked. What users need to know is that after setting, turn off the electric heating fan and cooling fan in turn, stop the main drive, remove the feed wheel, remove the support plate, open the doors on both sides, and reduce the temperature in the fabric setting machine room to below 100 ℃ , stop the hot air blower, exhaust blower, static eliminator and compressed air in sequence, and turn off the main power supply after a while. If any sudden failure occurs during the gray cloth operation, the machine should be stopped immediately, the gray cloth should be cut and pulled out, and the fault should be eliminated in an empty car. If it is used to guide the cloth before it is put into the machine, it is strictly forbidden to wear the cloth guide rope during the operation of the fabric setting machine, so as not to squeeze the hands and cause personal accidents. The filter screen should be cleaned once a day, and the lint and dirt in the oven, upper and lower air nozzles and the surrounding environment should be cleaned once a week.
https://www.sunwinmachinery.com/
