We know that during the operation of the stenter, three important process requirements, namely temperature, time and pressure, need to be properly controlled. In the tenter drying room, if the insulation layer of the drying room needs to be replaced or scrapped, the insulation material filled in it should be disposed of or destroyed according to local environmental protection regulations. As for the temperature control of the drying room, the process temperature is mainly set by the up and down keys on the temperature control table.
In the tenter drying room of the tenter setting machine, a corresponding burner is also arranged, mainly for heating the drying room. The temperature control meter controls the flame size to control the temperature. The contactor control logic starts and stops. The operation steps of the burner are as follows: first turn on the circulation fan, then turn on the burner key switch to allow the burner to work; and turn on the main machine to keep the vehicle speed above 5m/min; finally set the process temperature on the temperature control table. The burner is working.
The next step is to enter the air-cooling process, mainly to achieve the requirements of rapid cooling of the fabric. In the tail box of the tenter setting machine, the main operation contents are: adjusting the position of the needle removal, and putting down the roll when the cloth is passed through the tail of the machine; setting the process parameters on the man-machine interface ( Main engine speed); Turn on the main machine, run the machine out of the cloth rolling car; check the lubricating oil quality and oil quantity of the main engine transmission box according to the regulations, and lubricate the tail end amplitude adjustment screw according to the regulations.
It should be noted that at the end of the work, the field staff should properly adjust the tail nut of the roll cylinder of the tenter at the end of the stenter to keep the upper roller in the separated position. The main function of surface winding is to wind the finished fabric, which is suitable for the speed of 2~20 m/min.
When the tenter setting machine is wound, it can be carried out in different ways, such as manual, stop, and automatic. When manual, the speed of the vehicle is not controlled by the speed of the host line. The operator can set the speed arbitrarily. When it is automatic, the line speed is slightly faster than the host, and the tension of the cloth is adjusted by adjusting the winding speed. When stopped, the winding stops.
