For the adjustment of the center of the automatic stenter setting machine , the two sides of the fabric are placed in the center, and the feed port of the machine guides the configuration of the fabric at the exit. Since the discharge port of the upper belt guide machine is against the cloth roll, the guide belt stenter setting machine The feed input fabric outlet faces the machine, the drive belt of the stenter setting machine faces the roll cloth, the drive belt is embedded in the upper fabric, and the lower stenter setting machine drives the interwoven fabric as the guide belt and the guide belt of the stenter setting machine.
When the belt tractor placed in the stenter setting machine is set, it can make the fabric leave the needle machine tensioner, and further set it to avoid the deviation due to the organization, and at the same time reduce the labor intensity of the operator. The phenomenon of chain winding and the improvement of operating efficiency, now the machine center adjusts the hot air cylinder of the drive, the upper air outlet of the nozzle and the lower part of the outlet nozzle, the air separation return device to the lower part, the air passes through the upper air return device of the tenter setting machine, and the lower air Return to the device to obtain moisture on the surface of the fabric.
Because the upper air outlet and the bottom outlet air are discharged at the same time to prevent the flow of hot air at the tenter setting machine, this can ensure sufficient drying of the fabric. The center of the structure is equipped with a power link unit and a stainless steel sleeve punching convex The block is installed on the inner wall of the matching groove of the bearing inner ring, the center cylinder wear-resistant press wear-resistant cylinder is protruding, the wear-resistant cylinder block is nested in the corresponding recess on the inner wall of the stainless steel hub, and the upper and lower stainless steel bushing ends Formed by a row of teeth with two rings.
For the upper surface of the stenter setting machine, the column tooth ring surface is higher than the upper surface of the tooth column of the lower ring, and the tooth column of the upper ring is perforated in the groove, which does not guarantee the looseness of the fasteners. Sliding between parts, while reducing some installation components, saving production costs, the entire installation process can be completed by printing.
https://www.sunwinmachinery.com/
