To solve this problem, the recommended correct steps are:
1. Turn off the tenter setting machine and check whether there is this problem before production;
2. If it is found, it must be approved by the head of the shift before work. If it is not originally, the problems that should be paid attention to include: whether the dyed cloth has been dyed before or the finished product that is easy to color; whether there is cloth strip on the needle board, put it into the oven Check whether there is oil stains on the front support rods; when whitening or pad dyeing, whether the chemicals are uniform, etc., and deal with them according to the actual situation.
Common problem 2: The tenter setting machine has scratches on the cloth.
For this problem, it should also be checked whether there is such a problem before. If there is, it can only work after the permission of the shift leader. If there is no original, it should be checked whether the front cloth of the machine has rubbed against hard objects or the roller has Burrs, whether the blanking wheel is pressed too tightly, all of the above will cause scratches on the cloth of the tenter setting machine, and it must be adjusted before starting to work.
Frequently Asked Questions 3: The tenter-setting machine has a moon-curved shape, and there is a dead wrinkle mark on the roll.
In the same way, first check whether there are such problems before, if there is, you can work after obtaining consent. If there is no original, it is necessary to check whether the needle is normal on the machine, overfeeding is too large and the needle is easy to fall off, the edge blanking brush is bad, the edge blanking wheel position is too high, the pressure is not adjusted properly, the needle or needle plate is uneven, and the cloth is fed. Hemming, all of the above will cause problems such as pin-off or curling of the tenter and setting machine, and it must be repaired before starting to work.
Frequently Asked Questions 4: The tentering and setting machine outputs the cloth edge and hook.
For this problem, the recommended correct operation method is:
First, check whether the needle surface of the needle board is normal and whether there is any trace of scratches. If the brush wheel hair falls off, it will directly affect the needle surface and cause the needle tip to become hairy. , need to be replaced before it can work.
https://www.sunwinmachinery.com/
