During the daily use of stenter machine, users should not only pay attention to ensure the rationality and standardization of operation, but also take into account the safety issues. The so-called safety, not only requires to maintain the safety of the stretching machine equipment, but also to ensure the safety of staff. So, in practical work, what specific security issues should be paid attention to ?
First of all, about the storage location of the stenter machine equipment. Normally, the equipment should be placed in a relatively spacious, well ventilated environment without corrosive gases. In addition, the storage site of the equipment should be smooth and dry, and the concrete thickness of the foundation floor should not be less than 150 mm. At the same time, attention should also be paid to ensure that the needle plates on both sides are in a level and symmetrical position, and no position deviation is allowed.
Secondly, in the process of installing the equipment of the stenter machine, it is necessary to ensure that there are no impurities in its track or other phenomena that hinder the normal operation of the chain. In the process of installing transmission rollers, guide rollers and drop rollers, it is necessary to calibrate the parallelism between the rollers.
Thirdly, before opening the stretch setting machine equipment, we must pay attention to the environment at that time. Keep in mind that no other personnel shall stand near the equipment; no maintenance or maintenance personnel shall work. In addition, attention should also be paid to checking and ensuring that the temperature between the constant temperature of the electronic control box should be within the prescribed range. If dust and other debris are found in the electronic control box, it should be cleaned up in time.
In addition, before starting the temperature control program of the stentermachine equipment, the staff need to pay attention to check the transmission parts of the equipment in advance to ensure flexible operation. Then adjust the full width to the required width, and adjust it with the edge tracker. At the same time, adjust the overfeed to the predetermined value.
