Before the drop cloth operation, we need to do the relevant preparations first. Do you know what the preparation includes? Let's take a look at the specific content below, I hope it can help everyone! We need to clean the surface of the stenter equipment, the work surface, etc., especially the drop frame and the second half of the machine. After that, you also need to clean up the work site to avoid and clean around the equipment. In the second step, we need to pay attention to check whether the rear part of the equipment is normal, and check whether the auxiliary facilities such as the stacker are complete and intact, whether the setting of the cloth guide and threading route is reasonable, and whether it can meet the work requirements, etc. After checking and confirming that there are no abnormal problems, the third step is to understand the relevant information and requirements in advance, so as to master the process and quality requirements of the fabric to be processed, which also provides convenience for the later operation of the stenter. The fourth step is to put the cloth guide car in a suitable position, usually under the cloth drop frame, and prepare an empty car for receiving and releasing the produced processing cloth. In the fifth step, we should choose a suitable empty roll holder according to the specific properties of the fabric to be processed and production requirements. Afterwards, the position layout should be adjusted appropriately so that the winding roller and the cloth winding roller are parallel. After that, the staff can open the tenter setting machine at the same time to start the setting operation.
https://www.sunwinmachinery.com/
